Build the Mobile Phone Signal Flash Light Radiation Power Kit

I built the Mobile Phone Signal Flash Light Radiation Power DIY Suite from Ebay which costs about £1 from China. The circuit would flash an LED when there is an incoming or outgoing call from a mobile phone.

The components are:

1. 8050 transistor (3)
2. 1ss86 diode (Silicon Schottky Barrier Diode)
3. 0.01uF non-electrolytic capacitor (2) 
4. Copper wire to act as an inductor
5. Antenna wire
6. 1Mohm resistor (2)
7. 10Kohm resistor (2)
8. 220 ohms resistor (1)
9. 470Kohm resistor (2)

The circuit diagram is shown below:

The circuit is powered from 3v power supply, a CR2032 coin cell battery can also be used. When there is an incoming or outgoing call from a mobile phone, the LED begins to flash, the antenna wire needs to be close to the mobile phone as much as possible for better reception  The LED also turns on when the antenna wire is touched.